Anyone know a good TIG welder in Seattle area?

[btpeet@effervescent.com]

Looking for a shop that can do clean TIG welding on aluminum in the greater
Seattle area.  If anyone has a recommendation, I'd greatly appreciate it!
The project is fabrication of 16V fuel rails, which is a fundamental piece
of "plumbing" when you want fit any kind of EFI to the 16V motor.  Need to
TIG weld extension tubes to the rail.  The extension tubes reach down
through the intake runners to the injectors.  Size of the job is 5 fuel
rails, or 20 welds.

Please don't bother to e-mail me about fuel rails from Ross Machine Co, EIP
(which is made by Ross), or Momentum Motorsport.  I'm aware of those
products.  However, if you know of a 16V fuel rail for UNDER $150, I would
like to hear about it.

Thanks.

Bradley
88 Scirocco 16V 2.0 with no "t"  :(
96 Passat GLX Wagon


--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org