Re: Shining up manifold??

["Allyn" <amalventano1@home.com>]

yes, that is the way to do it, you wont have to start out with as course a grit on that top part
since it starts out fairly flat to begin with.
to get a mirror shine you may need polishing compound/wetsand at the very end. somewhere around the
2000 grit range is where you start getting mirrored.
al

Allyn Malventano, ET1(SS), USN
87 Rieger GTO Scirocco 16v (daily driver, 160k, rocco #6)
87 Jetta 8v Wolfsburg 2dr (daily driver, 260k, 0 rattles :)

----- Original Message -----
From: "Michael Leach" <scirocco16v_1@yahoo.com>
To: <scirocco-l@scirocco.org>
Sent: Monday, July 16, 2001 3:03 PM
Subject: Shining up manifold??


> My Manifold has been powdercoated for quite a while now and want to shine the section
> that has the 16v DOHC writing on it....I am guessing I start with coarse grit to get the
> powdercoat off and then move my way to fine to get it to shine afterwards but would like
> to hear this from someone else who has done it....thanks
>
> =====
> Michael Leach--Rochester,NY
> 87 16v
> 97 A4 2.8 quattro
>
> __________________________________________________
> Do You Yahoo!?
> Get personalized email addresses from Yahoo! Mail
> http://personal.mail.yahoo.com/
>
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org
>
>


--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org