Re: 4K vs 2H

["Jason" <jason87vw@nac.net>]

What I have is the flanges from a 16v trans (100mm) attached to the 4k
trans. The axles are 16v everything is 16v except for the tranny...What
you're saying is you can't put 100mm flanges on 8v axles...Or am I just not
getting it ???

----- Original Message -----
From: <thescirocco@juno.com>
To: <drew@dyermaker.cs.uoguelph.ca>
Cc: <scirocco-l@scirocco.org>
Sent: Monday, February 26, 2001 5:18 PM
Subject: Re: 4K vs 2H


>
>
> On Mon, 26 Feb 2001 17:15:15 -0500 (EST) drew
> <drew@dyermaker.cs.uoguelph.ca> writes:
> > 100 mm flanges were factory mated with 100 mm CV's to accomodate the
> > extra
> > power that certain engines put to the road.
> >
> > AFAIK the axles themselves are all the same on the same A platform,
> > just
> > the joints that were larger.
> >
> > Drew
>
> They are not the same...
>
> You can't PROPERLY fit 100mm inner CV's on a 90mm axle shaft.
>
> Btw, there is an iteresting thread on flange swaps at:
>
> http://forums.vwvortex.com/vwbb/Forum11/HTML/002132.html
>
> Peter
> '79 Scirocco 16V project car
> '83 GTI "Caged Rabbit"
> '84 Scirocco, RD/FF
> '80, '88 Scirocco rollers
>
> ________________________________________________________________
> GET INTERNET ACCESS FROM JUNO!
> Juno offers FREE or PREMIUM Internet access for less!
> Join Juno today!  For your FREE software, visit:
> http://dl.www.juno.com/get/tagj.
>
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org. To unsubscibe send
> "unsubscribe scirocco-l" in the message to majordomo@scirocco.org
>
>


--
Email LIST problems to: scirocco-l-probs@scirocco.org. To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org