[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: 16v questions

To: Brett Van Sprewenburg <brett@netacc.net>
Subject: Re: 16v questions
From: "T. Reed" <treed2@u.washington.edu>
Date: Thu, 23 Nov 2000 00:05:47 -0800 (PST)
cc: scirocco-l@scirocco.org
In-Reply-To: <v04210101b64219222176@[24.24.47.13]>
Sender: owner-scirocco-l@scirocco.org


Yeah I know it's 24mm, I just had a momentary brain lapse when typing
that. Sorry!

-Toby

--
'87 16v

On Wed, 22 Nov 2000, Brett Van Sprewenburg wrote:

> >16.5mm front
> >25mm rear
> >
> >-Toby
> 
>  From my knowlege, 24mm is correct, as stated by Scott below.
> The first upgrade size is 25mm, the 2nd 28mm.  Remember, relative bar
> "stiffness" increases as the cube of the diameter...so a 1mm increase is
> actually a pretty significant difference.
> 
> ==Brett
> 


--
Email LIST problems to: scirocco-l-probs@scirocco.org. To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org

References:
- Re: 16v questions
  - From: Brett Van Sprewenburg <brett@netacc.net>

Prev by Date: New Member!
Next by Date: Re: New Member!
Prev by thread: Re: 16v questions
Next by thread: P/S tierod question
Index(es):
- Date
- Thread