[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

SV: Oil Priming a new 16V

To: "Shannon Fenton" <sfenton@amazon.com>, "Scirocco List" <scirocco-l@scirocco.org>
Subject: SV: Oil Priming a new 16V
From: "Roland Johansson" <scirocco@mail.bip.net>
Date: Wed, 3 May 2000 10:19:26 +0200
Organization: 193.0.0.223
References: <NDBBIGOKDJKKPHPICEODGEJBCJAA.sfenton@amazon.com>
Sender: owner-scirocco-l@scirocco.org

Take the gear from a crashed motor, weld on an extension and voila, you have a nice pre-priming tool too atach too a drill. I think it might work with an 8V distributor that you cut away unnecessary parts from but I'm not shure if the oil pumps are identical.

Roland Johansson, Swedish Viking
Scirocco 1,8T -82
Http://hem.passagen.se/toker

>>Is there a tool out there to preprime a fresh 16V motor? Like a drill
attachment to spin the pump?>>






--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org

References:
- Oil Priming a new 16V
  - From: "Shannon Fenton" <sfenton@amazon.com>

Prev by Date: SV: Intake manifold question
Next by Date: Re: Scirocco-heaven
Prev by thread: Re: Oil Priming a new 16V
Next by thread: question
Index(es):
- Date
- Thread