Re: Problem found...

[Ben Patterson <bpatterson@stanford.edu>]

Aw crap.... so much for the 12mm I just bought yesterday. Argh....


			thanks again,
					Ben


>> >1) Anyone know what size allen key it takes to back off the rear
>> >calipers?
>>
>>
>>7mm hex.
>
>If we are talking about removing the caliper assembly from the car 
>then it is an 8mm allen (sorry Shawn ;) if we are talking about 
>removing the caliper from its pad carrier it should be a 13mm bolt 
>and a 15 or 17mm retainer rod to replace pads. HTH
>
>
>Chris DeLong
>ICQ#45030867
>Seattle, WA USA
>'80 16V Rag (Broken 2 Cylinder :()
>'80 Rocco (For Sale)
>'78 Scirocco
>'82 GLI
>'80 'Vert
>'65 Bus (ugly, but good for campin' W/toaster oven)
>'61 17 Window
>
>
>________________________________________________________________________
>Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com

_________________________________________________________________________
Ben Patterson 				Cell  - 650.274.7525
Networking/Macintosh			LiNCS - 650.725.4630
Systems Engineer			Email: bpatterson@stanford.edu
CRC-LiNCS/ITSS				Stanford University

"Try to remember there is no spoon..."
					- The Matrix 
______________________________________________________________________ 
___ 

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org