Re: Oil Pan Bolt Removal

["Jeff Wheeler" <j_dubbya@mindspring.com>]

That's exactly right; in fact, I got one at Sears that is a 10mm (not 100%
sure about the size) socket with a u-joint built in, for a 1/4" drive.  Very
easy to remove  with this tool.  Also easy to strip the threads on the way
back in, although I'm still not sure how I managed to do that.

----- Original Message -----
From: T Berk <tberk@mindspring.com>
To: <scirocco-l@scirocco.org>; <jvgvw@techie.com>
Sent: Sunday, June 04, 2000 3:27 PM
Subject: Oil Pan Bolt Removal


>
>
> If I remember right you need a universal joint in the mix to get at that
> pesky bolt between the trans and the motor.
>
> And 1/4" drive is easier than 3/8"?
>
> Trying to pass it on to this guy named Jason:
>
> < mailto:jvgvw@techie.com >
>
> tia,
> TBerk
>
> --
> Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
> "unsubscribe scirocco-l" in the message to majordomo@scirocco.org
>



--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org