Re: Self machining tranny question

[Shawn C Meze <skerocdriver@juno.com>]

On Mon, 17 Jul 2000 21:33:46 PDT "Chris DeLong" <green536@hotmail.com>
writes:
>All 020 gearboxes have the self machining problem if they have not 
>been upgraded to the bolt kit in the r/p.


Actually Christopher, the self machining problem was from the lack of the
2 X $0.10 clips. The pins get loose (wouldnt happen if the clips were
installed.)  and knock the rivots off the ring gear, kabang. Im sure you
already knew that but just forgot. :)


Shawn Meze
86' Jetta GLi 8V                   84' Scirocco 8V <--NEW
82' Scirocco GTi -FSP 30-   81' future "Project Scirocco FSP"
The Fastest, Quickest, Cleanest and best looking Scirocco in all of San
Diego!
http://www.Geocities.com/MotorCity/Speedway/1308/index.htm

________________________________________________________________
YOU'RE PAYING TOO MUCH FOR THE INTERNET!
Juno now offers FREE Internet Access!
Try it today - there's no risk!  For your FREE software, visit:
http://dl.www.juno.com/get/tagh.

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org