[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Clutch Q's



<x-charset iso-8859-1>that's what I meant.. for the CV joint bolts.

8mm triple square.. 

mark

-----Original Message-----
From: owner-scirocco-l@scirocco.org
[mailto:owner-scirocco-l@scirocco.org]On Behalf Of thescirocco@juno.com
Sent: Wednesday, October 13, 1999 11:16 AM
To: scirocco-l@scirocco.org
Subject: Clutch Q's




On Wed, 13 Oct 1999 10:19:05 -0600 Mail Delivery System s: 0
> 
> I couldn't remember the 190mm flywheel bolt size, but I knew they 
> were at
> least 10mm. I just went out to my garage and checked it, it is 11mm 
> and
> it is hex.
> 
> The 210mm flywheels are 9mm and 12 pointed, I remeber that, because 
> all I
> had were 6 pointed sockets and I had to drive to Sears in the middle 
> f
> the job.
> 
> Peter
> 
> On Wed, 13 Oct 1999 07:55:38 -0700 "Mark Madison" 
> <mmadison@aracnet.com>
> writes:
> > I'm voting for the 8mm.  I removed the tranny in my 84 GTI and it 
> > used this
> > socket... I also found that in older cars... my 78 Scirocco it had 
> a 
> > hex..
> > not
> > 12pt and I believe it was a 6mm.
> > 
> > mark
> > 
> > 
> > --
> > Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe 
> send
> > "unsubscribe scirocco-l" in the message to majordomo@scirocco.org
> > 

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org


--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org


</x-charset>