Re: RE: Motronic engine swap done!

[VWN8@aol.com]

In a message dated 10/4/99 1:05:20 PM, SnowJ@aetna.com writes:

<<What about those mounts ? I am guessing that there stronger than the stock
16V mounts, What are they made off ? Vulcanized rubber ??? :)>>

hmmm, did I miss somthing? What mounts. If you mean the motor mounts I used:
stock trans
motorsport RH
motorsport rear
poly front

I used to use all poly (all 4!) so my new setup doesnt have vibration to an 
unplesant extent.

Hope that was the question

Nate

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org