Re: VDO T-Fitting???

[T Berk <tberk@mindspring.com>]

"Oen, Shawn" wrote:
> 
> Where can I get a T-fitting so that I can install 2 oil temp senders on the
> oil filter housing?  There is only room for 1 oil temp sender (MFA) and I
> would like to hook up my VDO oil temp gauge also.  I tried to spice into the
> existing wiring to get a reading but found out that will not work due to the
> nature of the sender....
> 
> Any suggestions?  Otherwise I will use the oil temp gauge for coolant temp
> since it goes up to 270 degrees....But I have never seen a VDO coolant temp
> sender either.....
> 
> thanks, shawn

I was at the pick n' pull Sun and got a few sensors. I should have just
grabbed the whole  oil filter mount because it has TWO sensor locations
n it. Seems this is the way to go,  because the sensor to gauge package
doesn't have to serve to masters.

TBerk

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org