Re:O2 sensor question '88 16v

[Jim Jarrett <jarrett@kodak.com>]

On Wed, 26 May 1999 00:57:30 EDT IraT@aol.com wrote:

>I have heard of purchasing a non Bosch O2 sensor (3 wire) without the
>electrical connection.  But cut and splice using the old connector wit the
>new sensor.  Is this possible?  Any other recommendations would be greatly
>appreciated.  Thanks.

Actually, what I think you want is the Bosch "generic" O2 sensor.  You just
cut off the electrical plug for the new one, and the wires for the old one
at the base of the old one, and solder them together.  Simple.

Related question:  Does anyone know if you can get the other side of the
connector for these standard Bosch O2 sensors and wire them in?  It would
make sensor replacement much easier...

+-------------------------------------------------------------------+
| Jim Jarrett,CCP                                                   |
| Eastman Kodak Co. - Professional Digital Cameras                  |
| 901 Elmgrove Road MC 35504                                        |
| Rochester, NY 14653-5504         Phone:(716) 726-6365             |
| jarrett@kodak.com           All opinions expressed are mine alone |
| http://www.kodak.com                                              |
+-------------------------------------------------------------------+



--
To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
If you experience other problems, email: scirocco-l-probs@scirocco.org