Re: I got an OIL LEAK!!!

[Brad Sterling <bgsterling@earthlink.net>]

Ah ha!  I see the light.

-Brad

Brett P VanSprewenburg wrote:

> ---Brad Sterling <bgsterling@earthlink.net> wrote:
> >
> > Okay, it mostly makes sense.  One question.  You mention that I can replace
> > either the low or the high sensor with a dual sensor.  But then later on,
> > you say to check the pressure numbers to make sure I'm replacing the
> > appropriate sensor.  So which is it?  Does the dual sensor replace either
> > existing sensor or do I need to  replace either the high or low specifically?
> >
> > -Brad
> >
>
> Well, you may not like this, but the answer is: Yes. :/
>
> Here's the story:  One of those sensors is for low pressure readings, one
> is for higher pressure readings.  Either one will work in either hole. The
> dual sender will either be a gauge/low pressure sender replacement _or_ a
> gauge/high pressure sender replacement.  Read the tiny little numbers
> written on the side of the dual sender and the stock senders to find out
> which one it's supposed to replace.  That was what I was trying to say,
> was this better? :)
>
> ==Brett
>
> _________________________________________________________
> DO YOU YAHOO!?
> Get your free @yahoo.com address at http://mail.yahoo.com
>
> --
> To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
> If you experience other problems, email: scirocco-l-probs@scirocco.org


--
To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
If you experience other problems, email: scirocco-l-probs@scirocco.org