RE: headers?

[Brian Honnold <bhonnold@pac-cap.com>]

When I still had my 1.6, the try-y gave a noticable increase above 3500Rpms 
with no givaway down low. When I went to the 1.8 with a 2.25 exhaust, the 
headers seemed to make lostsa power everywhere in the range.

Definetely get the poly front mount though and be sure to bolt the header 
to the lower block and tranny brace.

Does it have a flex joint?????

Brian Honnold
'78 Rocco Ragtop

On Tuesday, October 27, 1998 8:39 AM, Alex Ting 
[SMTP:alex@millenniumsolutions.net] wrote:
>
> I know this subject has been touched on many times,
> but I just bought a tri-y header and would like to get
> some opinions.  It is an autotech or BMS or something
> similar.  All I really know is that it's new, already wrapped,
> and has the 02 sensor port.
> The only headers I've used were 4 into 1s, which were
> horrible.
> Does anybody out there have practical experience?
> Compared tri-ys against a dual manifold/aftermarket downpipe?
>
> TIA
>
>
> Alex Ting
> Millennium Solutions Group, Inc.
> 8303 Sierra College Blvd., Suite 150
> Granite Bay, CA 95746
>
> Phone: 888-801-2001 or 916-797-9998
> Fax: 916-797-9997
> Email: alex@millenniumsolutions.net
>
>
> --
> To subscribe or unsubscribe, send email to 
scirocco-L-request@scirocco.org,
> with your request (subscribe, unsubscribe) in the BODY of the message.
- --
To subscribe or unsubscribe, send email to scirocco-L-request@scirocco.org,
with your request (subscribe, unsubscribe) in the BODY of the message.

------------------------------