Spring Tooling pt1

[julie at menloparkrandd.com (julie@menloparkrandd.com)]

The wonder tool. Just don your gloves and face shield, grab the grinder in both hands Raise it high and SCREAM. 
This is garanteed to get any thing to drop its nuts!

>-----Original Message-----
>From: Eric Person [mailto:scirocco25@gmail.com]
>Sent: Thursday, May 4, 2006 12:11 PM
>To: 'scirocco list'
>Subject: Re: Spring Tooling pt1
>
>Time to find someone with an angle grinder. There's always one bolt on any
>project that fails to loosen.
>
>Eric
>
>On 5/4/06, Tonee Northam <pb3vr6@yahoo.com> wrote:
>>
>> So,
>>
>> Yesterday was day 1 of many to come getting the 84 8v ready for cincy.
>> Very minor thing really except for the either bad altenator/battery issue
>> and idle surging it's really not bad.
>> I got a entire rear bumper from Eric P.(thanks again) to swap out with
>> the old one that has broken clips on the cover. So, me thinks I can just
>> remove the entire thing put on my freshly painted one and that's it, well,
>> until I got down to the last bolt holding on like the titantic was going
>> under.
>> Snapped the welded-on nut on the back side arm, now she's spinning
>> freely like a 2-year old on a merry-go-round. So last night I decided that's
>> enough to mess with and moved on to other things like the radio, got that
>> figured out, but I looked in the "good book" and can't find out how to
>> replace the fender mounted antenna, do I just remove the fender liner or is
>> it accessible from the inside?
>>
>> Back to the garage, can't beat 70 degree weather for tooling.
>>
>> TIA
>>
>> Tonee
>> _______________________________________________
>> Scirocco-l mailing list
>> Scirocco-l@scirocco.org
>> http://neubayern.net/mailman/listinfo/scirocco-l
>>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l
>