[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
MS diagram?
Ok. Thats what I am asking. I am doing a wiring diagram (as its either 96 degrees or raining). If the rain stops I'll go build the VS frame for the engine.
>-----Original Message-----
>From: Dan Bubb [mailto:jdbubb@verizon.net]
>Sent: Saturday, July 22, 2006 12:26 PM
>To: julie@menloparkrandd.com, 'Org, Scirocco'
>Subject: Re: MS diagram?
>
>No, no no!
>There's no reason to do that.
>CIS and MS have virtually nothing in common as far as the wiring is
>concerned. The only thing MS needs in the stock wiring is an output from the
>coolant temp sensor and I'm of the opinion you should install a separate GM
>sensor for them MS anyway.
>16V KS ignition will also have no common wiring except the hall sensor input
>and now that I think about it you ain't using that anyway since you're going
>to be using a crank trigger.
>Once you remove the CIS and stock ignition you will only have coolant and
>oil sensor wiring and "power" wiring. i.e. alternator, starter, battery.
>Use the MS relay board, get power and ground directly at the battery and the
>MS harness is completely separate from the rest of the wiring.
>
>
>From: <julie@menloparkrandd.com>
>Sent: Saturday, July 22, 2006 12:01 PM
>Subject: MS diagram?
>
>
>> Any one have a diagram of an MS wired in to a stock MKI harness?
>>
>> _______________________________________________
>> Scirocco-l mailing list
>> Scirocco-l@scirocco.org
>> http://neubayern.net/mailman/listinfo/scirocco-l
>>
>
>
>
>