90mm vs 100mm - that is the question

[foxxinabox at wideopenwest.com (Foxx (in a box))]

>>I think that you will find that the 100mms willnot fit on the 
>>axles with out some modification to the cv joint spline or the axles.
> 
> 
> I've never seen any need to mod splined portion of half shafts, nor the axle
> portion. What required you to do this?

   i, too, am confused about this. i have taken apart both 90mm and 
100mm hub carriers and only show slight differences between the two. 
despite the fact that they have different part numbers on the etka, the 
only difference that i can find is that the 100mm carrier is slightly 
deeper, in terms of the bearing hole depth. i am confused as to why this 
would cause a problem if one were to install a 100mm axle into a 90mm 
carrier as there would be more clearance. the hubs, themselves, are 
exactly the same for 90mm and 100mm, as are the bearings.

-- 
  /\_/\	  Foxx (in a box)
< o o >	  http://foxx.tripod.com
   \ /
    ?