crank shaft removal

[area53 at validpath.com (Jeff Toomasson)]

Though I don't know exactly "why", I would try screwing the crankshaft
pulley bolt back in and turning it clockwise.

HTH, JT
----- Original Message ----- 
From: "koabi" <saracornelous@mcleodusa.net>
To: <scirocco-l@scirocco.org>
Sent: Monday, July 19, 2004 6:53 PM
Subject: crank shaft removal


> This is for an ABA if that makes a difference though I had the same
> issue for my 9A.
>
> I'm reluctant to use force, but the main bearings are unbolted, the
> front and rear main seal housings are off, and the rod end caps are off.
> Why can't I get the crank to drop?
>
> TIA,
>
> Koabi
>
> 88 Scirocco 0v
>
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l