Rear 16v spoiler

[flaatr at yahoo.com (Euroroc II)]

Factory spoilers are not glues to the window... it just sits there. There 
may be some sealent on the sides against the body but I can't remember and 
I just removed one from yard two weeks ago.

-Raffi


At 03:15 PM 2/6/2004, Rob Calderwood wrote:
>I also had to use a knife to cut away the glue holding the spoiler to the
>window.
>Rob
>----- Original Message -----
>From: "Euroroc II" <flaatr@yahoo.com>
>To: "Chad Eatock" <ceatock@sympatico.ca>; "scirocco list"
><scirocco-l@scirocco.org>
>Sent: Friday, February 06, 2004 12:14 PM
>Subject: Re: Rear 16v spoiler
>
>
> > New supports can be had for about $20... check Potter or Adirondack.
> >
> > To remove the spoiler there on a 16V there are 3 screws on each side that
> > go thru the hatch and thread into the spoiler... 2 near the bottom and one
> > mid span plus there is 1 nut up at the top near the hinge that must be
> > removed. The spoiler then comes right off.
> >
> > -Raffi
> >
> > At 11:45 AM 2/6/2004, Chad Eatock wrote:
> > >What is the procedure of removing the stock rear hatch spoiler?  is it
> > >necessary to be removed when repainting the car?
> > >Also,  my rear hatch supports are pooched....and the hatch smashed me in
> > >the head last week as the hockey stick support I had crafted slipped
> > >away.....is there replacement supports or used good ones out there?
> > >Chadster '87 16v
> > >
> > >_______________________________________________
> > >Scirocco-l mailing list
> > >Scirocco-l@scirocco.org
> > >http://neubayern.net/mailman/listinfo/scirocco-l
> >
> >
> > _______________________________________________
> > Scirocco-l mailing list
> > Scirocco-l@scirocco.org
> > http://neubayern.net/mailman/listinfo/scirocco-l
>
>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l