Electrical contacts

[rocco_crossing at hotmail.com (Rhett Farnum)]

OK this may not be the most "original" idea but as far as I can tell most of 
the connector in our engine bays are simple spade connectors that are 
different widths. So I would just get a bunch of those and start 
crimping/soldering away!



Peace Out,
Rhett
Rocco_crossing
'83 Rocco (DEAD!!) :-(  Now what to do???
Buy a GTI!! Got an '83 for that too!!





>From: "Dan Bubb" <jdbubb@ix.netcom.com>
>To: <scirocco-l@scirocco.org>
>Subject: Electrical contacts
>Date: Fri, 30 Apr 2004 09:14:22 -0400
>
>Anybody know how to decipher what electrical contacts go with what 
>connector housings in ETKA?
>I can find the connector on the engine harness, so I have that part number.
>And in ETKA under "special catalogs" they list numbers for the contacts 
>that go with the connector,
>but these are all wires with a contact crimped on each end.
>I just want the contacts (not already crimped on a wire) so I can build an 
>engine harness from
>scratch
>Basically, I'm looking for the little flat blade electrical contacts that 
>are used all over our
>engines. Distributor, cold start valve, thermotime switch.......
>Anybody know the part number or a way to figure out what it is?
>Thanks
>Dan
>
>
>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l

_________________________________________________________________
FREE pop-up blocking with the new MSN Toolbar – get it now! 
http://toolbar.msn.com/go/onm00200415ave/direct/01/