[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Diff excavated! And a new way to extand a gear puller
Holy Huge Images, Batman! What a Cheapass Classic! Mind if I someday put that on my tranny
teardown site?
Hell, I thought some Home Depot flat stock extensions were cheapass...but man, you take the cake!
But then again, I have been known to do certain jobs with rope (someone is bound to drag out a
particular old image, so I'm being pre-emptive).
Nice work!
Ron
--- stetson <tim@unrealexpectations.ath.cx> wrote:
> Even though I will be looked upon as the poor ignorant inbred errr......
> umm.....naive wrencher I am for imparting this, I cannot hide my glee!
>
> I can finally start REBUILDING the tranny! (well @ least start work on the
> diff!)
>
> I bought real circlip pliers today and went home and w/i 30 sec. had the
> last stubborn one off, After that it just seemed to spring
> apart (especially the synchro catchs!) until it came to pulling 1st gear.
> Then I found I didn't have a gear puller w/ long enough jaws.
>
> Consternation ruled for about 5 min., and then foolhardiness and faith
> in the indestructablity of the square knot took over.
>
> The results can be seen at:
>
> http://unrealexpectations.ath.cx/gears/index.html
>
> The newly improvised tool took 3 revisions until it functioned as
> required, but it only had to succeed once.
>
> K....now to wash the shell clean and treat the exterior for oxidation and
> then paint it? I'm waffling on this one....
>
> 9A deconstructed, now to see if I can put it back together!
>
> Tim
>
> The system was down for backups from 5am to 10am last Saturday.
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
__________________________________
Do you Yahoo!?
Yahoo! Small Business $15K Web Design Giveaway
http://promotions.yahoo.com/design_giveaway/