Rebuilding with molly lub

[txrocco at sbcglobal.net (ATS - Patrick Bureau)]

the only lube an engine needs when rebuilding it is ND30 (non detergent 30
weight oil) I usually used 2 qtrs during rebuilds


ATS - Patrick Bureau - txrocco@sbcglobal.net
----------------------------------------------
MSN:ATSGTX@hotmail.com |YAHOO:ATSGTX@yahoo.com
ICQ:32918816           |AIM:Texasscirocco
----------------------------------------------


=>-----Original Message-----
=>From: scirocco-l-bounces@scirocco.org
=>[mailto:scirocco-l-bounces@scirocco.org]On Behalf Of Dan Bubb
=>Sent: Friday, September 26, 2003 10:32 AM
=>To: shawn f; scirocco list
=>Subject: Re: Rebuilding with molly lub
=>
=>
=>Definitely not on the pistons and rings (perhaps those should be assembled
=>dry?). I'd think it would be good most other places as long as it isn't
=>wheel bearing Moly lube. That would be a little heavy!
=>Dan
=>
=>----- Original Message -----
=>From: "shawn f" <falzsf@mts.net>
=>To: "scirocco list" <scirocco-l@scirocco.org>
=>Sent: Friday, September 26, 2003 10:49 AM
=>Subject: Rebuilding with molly lub
=>
=>
=>What does everyone think of rebuilding the engine with molly lube? If yes
=>where should i use it. I belive they say use iot on the top of
=>the cam caps
=>not sure where else though.
=>_______________________________________________
=>Scirocco-l mailing list
=>Scirocco-l@scirocco.org
=>http://neubayern.net/mailman/listinfo/scirocco-l
=>
=>
=>
=>_______________________________________________
=>Scirocco-l mailing list
=>Scirocco-l@scirocco.org
=>http://neubayern.net/mailman/listinfo/scirocco-l