balancing.

[falzsf at mts.net (shawn f)]

Ok i will just give them a nice sandblast so there are clean of dirt...
thanks....
----- Original Message ----- 
From: "Dave Ewing" <MK1Scirocco16v@comcast.net>
To: "shawn f" <falzsf@mts.net>
Sent: Monday, October 27, 2003 11:36 PM
Subject: RE: balancing.


> I would paint them after you get the stuff balanced.  HTH!
>
> Dave
>
> -----Original Message-----
> From: scirocco-l-bounces@scirocco.org
> [mailto:scirocco-l-bounces@scirocco.org]On Behalf Of shawn f
> Sent: Monday, October 27, 2003 9:09 PM
> To: scirocco list
> Subject: balancing.
>
>
> Well since my engine build got delayed i decided i should get it balanced.
> They (the machinist) want my Rod, one set of con rod bearings, one set of
> rings, The crank, flywheel and bolts, cluch, pressure plate, front
srocket,
> with bolt and pulley. I was wondering i sanblasted (another get air tool i
> got recently, sand blasting cabinet) the parts pulley and sprocket that is
> and was wondering if it would be ok to paint these parts. Just wondering
if
> they mind i guess it doesnt matter. Problem i was thinking is if they have
> to grind some of the parts there goes the paint. I guess i can touch any
> areas ground down. But then that may throw it out of balance again. Anyone
> know how much redline i can expect. I relize that i still need a better
cam
> and stronger springs in the future, but when i get some good springs what
> redline can i expect. Any things i should stress with the machine shop?
Any
> advice would be great...
>
> Shawn F
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
> ---
> Incoming mail is certified Virus Free.
> Checked by AVG anti-virus system (http://www.grisoft.com).
> Version: 6.0.530 / Virus Database: 325 - Release Date: 10/22/2003
>
> ---
> Outgoing mail is certified Virus Free.
> Checked by AVG anti-virus system (http://www.grisoft.com).
> Version: 6.0.530 / Virus Database: 325 - Release Date: 10/22/2003
>
>