shift linkage ball stud size?

[ralexander03@snet.net (Rick Alexander)]

Check http://www.mcmaster.com page 1041. Those are the ones I'm using. Cost
a bit more but will NEVER wear out.

Rick Alexander

----- Original Message -----
From: <treed2@u.washington.edu>
To: <scirocco-l@scirocco.org>
Sent: Monday, March 10, 2003 11:16 PM
Subject: shift linkage ball stud size?


> I"m going to place an order with McMaster-Carr in the coming days and I
> was wondering if anyone knew the correct size of the metal ball-joint
> thingies in the shift linkage. I tried to measure with a set of calipers
> but got an inconclusive result - either 12mm or 13mm.
>
> TIA,
>
> -Toby
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>