Bearings-> Tool I'm planning on using

[amalventano@sc.rr.com (Allyn)]

umm, $20 at the shop? you are lucky if you only spent that much to get
bearings pressed in.
Al

----- Original Message -----
From: "Patrick Bureau" <txrocco@sbcglobal.net>
To: "Tobias ><" <scirocco16v88@hotmail.com>; <scirocco-l@scirocco.org>
Sent: Tuesday, March 04, 2003 8:17 PM
Subject: Re: Bearings-> Tool I'm planning on using


> and the price tag to this tool compared to 20$ getting
> it done at a shop ?
>
> --- "Tobias ><" <scirocco16v88@hotmail.com> wrote:
> >
> > Since there's been some skepticism regarding the
> > bearing puller - here is a
> > link to a page that demonstrates how the a tool like
> > this works.
> >
> > Comes with various adaptors to different sized
> > bearings.
> >
> > http://www.hazet.de/deutsch/presse/presse12.htm
> >
> > 3 pics at the bottom: removing the bearing,
> > installing the bearing,
> > installing the hub.
> >
> > Incidentally, Potter has such a tool listed in the
> > tools section  ;-)
> >
> > T
> >
> >
> _________________________________________________________________
> > MSN 8 with e-mail virus protection service: 2 months
> > FREE*
> > http://join.msn.com/?page=features/virus
> >
> >
> > _______________________________________________
> > Scirocco-l mailing list
> > Scirocco-l@scirocco.org
> > http://neubayern.net/mailman/listinfo/scirocco-l
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l