[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Put driveshaft on and also put on axle nut,but still doesn't move



I just realized something, I forgot to put the washer
back on before putting the axle nut, what are the
problems with this?  I am going to tomorrow, put it
on.
--- Andrew Wong <mkii_84@yahoo.com> wrote:
> The first time I got my inner CV connected, I found
> a
> ball bearing on the ground, I put it back where it
> was, supposed to be when I reconnected it.  I still
> have my old inner CV, would it be worth it to swap
> out
> the old one for the new one?  For some reason I
> think
> the ball bearing moved and is not in the correct
> location causing the car not to move again
> --- L F <rocco16v@netzero.net> wrote:
> > You didn't happen to find several big,
> > grease-covered steel balls laying on the floor
> when
> > you got done, did you?
> > 
> > Larry
> > 
> >   sounds like you bent outer cv to the point of
> > disengaging it.
> >   Al
> > 
> >   > What I was doing was replacing my old
> driveshaft
> > with
> >   > a new remanufactured one just so I could drive
> > it
> >   > around again.  The problem is while, I
> installed
> > the
> >   > driveshaft(I tightened the triple square
> bolts)
> > and
> >   > used my breaker bar for the axle nut for the
> > outer CV
> >   > area, when I tried to drive it, it would not
> > move with
> >   > the new driveshaft and would make some noises
> > comming
> >   > from the inner CV, while in gear, I let the
> car
> > run
> >   > since it did not stall and looked at the
> > driveshaft,
> >   > it was spinning like it was wobbling.  The
> axle
> > nut
> >   > was not spinning at all.
> >   > --- T Berk <"TBerk "@sbcglobal>,
> >   > UNEXPECTED_DATA_AFTER_ADDRESS@.SYNTAX-ERROR.
> > wrote:
> >   > > Andrew Wong wrote:
> >   > > >
> >   > > > Today I got around to loosening the axle
> nut
> >   > > slightly
> >   > > > more than before and putting the bolts of
> > the
> >   > > inner CV
> >   > > > in, I don't think I tightened it tight
> > enough, the
> >   > > > axle nut and inner CV bolts because when I
> > started
> >   > > the
> >   > > > car, and put it in reverse, it did not
> move
> > still.
> >   > >  I
> >   > > > looked at the axle and it was spinning
> like
> > it was
> >   > > > wobbling.  Any ideas?
> >   > > >
> >   > > > =====
> >   > > > -Andrew Wong
> >   > > > 1984 Black Scirocco
> >   > > > 1987 White Quantum wagon
> >   > > >
> >   > >
> >   > >
> >   > > Hmm,  I need you to describe this again.
> >   > >
> >   > > There is the transaxle, it connects to the
> > inner CV
> >   > > joint via the
> >   > > tripplesquare bolts. The Inner CV has one
> end
> > of the
> >   > > axle stuck into it,
> >   > > the other end has the Outer CV with it's
> > splines
> >   > > that fit into the hub.
> >   > >
> >   > > If you have (at least) two or more than of
> > those
> >   > > inner CV bolts in then
> >   > > the only place you might be able to spin the
> > axle
> >   > > without getting the
> >   > > wheel to turn is a CV that has the axle
> pulled
> > out
> >   > > of it, OR you don't
> >   > > have the axle far enough into the hub.
> >   > >
> >   > > btw- On my K. Ghia I spun the spines off one
> > of the
> >   > > rear drive axles
> >   > > because the capture nut on the axle had back
> > out
> >   > > some.
> >   > >
> >   > > 'Splain it again so I can visualize 1. What
> > you had
> >   > > to start with and 2.
> >   > > what you are doing to try and fix it.
> >   > >
> >   > >
> >   > > TBerk
> >   > >
> >   > >
> > _______________________________________________
> >   > > Scirocco-l mailing list
> >   > > Scirocco-l@scirocco.org
> >   > >
> > http://neubayern.net/mailman/listinfo/scirocco-l
> >   >
> >   >
> >   > =====
> >   > -Andrew Wong
> >   > 1984 Black Scirocco
> >   > 1987 White Quantum wagon
> >   >
> >   > __________________________________
> >   > Do you Yahoo!?
> >   > Yahoo! SiteBuilder - Free, easy-to-use web
> site
> > design software
> >   > http://sitebuilder.yahoo.com
> >   >
> >   >
> _______________________________________________
> >   > Scirocco-l mailing list
> >   > Scirocco-l@scirocco.org
> >   >
> http://neubayern.net/mailman/listinfo/scirocco-l
> > 
> > 
> >   _______________________________________________
> >   Scirocco-l mailing list
> >   Scirocco-l@scirocco.org
> >   http://neubayern.net/mailman/listinfo/scirocco-l
> > 
> > 
> 
> 
> =====
> -Andrew Wong 
> 1984 Black Scirocco
> 1987 White Quantum wagon
> 
> __________________________________
> Do you Yahoo!?
> Yahoo! SiteBuilder - Free, easy-to-use web site
> design software
> http://sitebuilder.yahoo.com
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l


=====
-Andrew Wong 
1984 Black Scirocco
1987 White Quantum wagon

__________________________________
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com