[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Removing door stops???



You have to remove the bolts on the body side of the hinge, 17mm(or 15mm) I
believe, that will get your door off (two person job) also unplug the wires
inside the car, not the door, and push the little pin out of the bar thingy
near the bottom (the thing that stops the door from opening too far).

easy peasy

as for removing the pins from the hinges, Ya got me.?

Jason Adams
Fahrvergnugen Forever!


From: "Eric J Anastas" <aireq@softhome.net>
To: "'ATS - Patrick Bureau'" <pbureau@attbi.com>; <aireq@u.washington.edu>;
<scirocco-l@scirocco.org>
Sent: Tuesday, September 17, 2002 12:21 PM
Subject: RE: Removing door stops???


> The bentely says to remove the screws that attached the door stop
> bracket to the door. I done that and the bracket is loose and moves
> around, but It's not obvious to me what I'm supose to do to actualy get
> the door off.
>
>
> eric
>
> > -----Original Message-----
> > From: scirocco-l-admin@scirocco.org
> > [mailto:scirocco-l-admin@scirocco.org] On Behalf Of ATS -
> > Patrick Bureau
> > Sent: Tuesday, September 17, 2002 12:03 PM
> > To: aireq@u.washington.edu; scirocco-l@scirocco.org
> > Subject: RE: Removing door stops???
> >
> >
> > I would like to know this also, I have a sagging and now
> > "loose" passenger door, that needs the pins replaced (got the
> > kit from dealership) but tried with a 5lbs hammer abnd could
> > not even beging to get the pins to budge.
> >
> > -------------------------------------------------------
> >     __  __________
> >    /  |/_ __/ ___/ Patrick Bureau
> >   //| | / / \__ \  1985 8v Prowler Orange "Beatrice"
> >  / _  |/ / ___/ /  1985 8v Titian Red "Lucky"
> > /_/ |_/_/ /____/   http://www.longcoeur.com/scirocco
> >
> > =>-----Original Message-----
> > =>From: scirocco-l-admin@scirocco.org
> > =>[mailto:scirocco-l-admin@scirocco.org]On Behalf Of Eric J Anastas
> > =>Sent: Tuesday, September 17, 2002 1:25 PM
> > =>To: scirocco-l@scirocco.org
> > =>Subject: Removing door stops???
> > =>
> > =>
> > =>I'm tearing appart my wrecked 16v, and for the life of me I
> > can't figure =>out how to remove the doors. How do you get
> > the pins out which connect =>the door stops to the body? Or
> > is there another way to do it? => =>eric => =>
> > =>_______________________________________________
> > =>Scirocco-l mailing list
> > =>Scirocco-l@scirocco.org
> > =>http://neubayern.net/mailman/listinfo/scirocco-l
> >
> >
> > _______________________________________________
> > Scirocco-l mailing list
> > Scirocco-l@scirocco.org
> > http://neubayern.net/mailman/listinfo/scirocco> -l
> >
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>