Rear fill plate

[brianm@zbt62.eastnet.gatech.edu (Brian McGarvey)]

Joe,
For the small numbers that we are talking here. using a soft tool is much
more feasable. and instead of costing 5000.0 per tool you run a 500.00
cost for the tool. I know cause we did this for some antennas.
brian



 On Fri, 22 Mar 2002, Joe Doty wrote:

> What he said.
>
> Having worked in an injection molding plant, I can tell you if you had it
> made, whoever made it would probably sell you them for $15-20 apiece.  Made
> out of say, polyprop or ABS.  However, the tooling is the expensive part.
> This is just from what I've noticed from the relative size of the part.
> Someone front $5000 for a mold and we'll go from there. :)
>
>
> >If the price is right I would go for 2 and maybe even 3.
> >
> >Brian
> >
>
> _________________________________________________________________
> Chat with friends online, try MSN Messenger: http://messenger.msn.com
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>