Front Lower Stress Bar bolt Pattern?

[76Rocco@earthlink.net (Curt)]

This is what I did although it requires using an angle head drill, I mounted
the bar w/control arm bolts, marked mounting holes that needed drilled,
center punched AGAP, then drilled a small (1/8") hole with angle head drill
from the top through the mounting holes, then drilled final hole from
underneath, installed bolts and it's Perfect! Hope this helps.

Curt
Bakersfield, CA
'76 Scirocco 8V
76Rocco@Earthlink.net

----- Original Message -----
From: "Rick Kellner" <rfkellner@snet.net>
To: <scirocco-l@scirocco.org>
Sent: Wednesday, June 12, 2002 4:35 AM
Subject: Front Lower Stress Bar bolt Pattern?


>   I picked up a stock, front lower stress bar from a 16v Scirocco that I
> want to put on my 84 8v.  Since this was not a stock component for my car
I
> will need to drill two holes for the back mounts.  Since the bar mounts on
> top there is no way to drill accurately from the bottom.
>        Does anyone have a diagram they could scan or fax showing the bolt
> pattern?  Any suggestions?  Thanks Rick Kellner.
>
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l