tranny swap

[drew@dyermaker.cs.uoguelph.ca (drew)]

None had non-removable output flanges, as that's how you replace the
seals.  However, flanges from earlier 020 gearboxes (earlier than 08/93
'ish) won't interchange with later 020 gearboxes, as I understand it.

Drew

On Mon, 10 Jun 2002, Neal Tovsen wrote:

> I thought some of the trannies had non-removable output flanges...
> 
> > -----Original Message-----
> > From: scirocco-l-admin@scirocco.org 
> > [mailto:scirocco-l-admin@scirocco.org] On Behalf Of drew
> > Sent: Monday, June 10, 2002 3:47 PM
> > To: ATS - Patrick Bureau
> > Cc: jim b; scirocco-l@scirocco.org
> > Subject: RE: tranny swap
> > 
> > 
> > On Mon, 10 Jun 2002, ATS - Patrick Bureau wrote:
> > 
> > > (IE: cannot put 100mm flanges on the ACN, but you can put 90mm on a 
> > > 9A, hope this make sense to you...)
> > 
> > I'm not sure what you were aiming to say here Patrick, but 
> > you can put 100mm flanges on an ACN in the same way you can 
> > put 90mm flanges on a 9A. However, you can't bolt 100mm inner 
> > CV's to 90 mm flanges... :)
> > 
> > BTW, that ATS looks pretty damned sweet with that body kit.
> > 
> > Drew
> > 
> > 
> > Drew MacPherson - '84 Wolfsburg Edition Scirocco TurboDiesel
> > 
> > 
> > 
> > _______________________________________________
> > Scirocco-l mailing list
> > Scirocco-l@scirocco.org 
> > http://neubayern.net/mailman/listinfo/sciro> cco-l
> > 
> 

Drew MacPherson - '84 Wolfsburg Edition Scirocco TurboDiesel