Transmission question

[pbureau@attbi.com (ATS - Patrick Bureau)]

So technically, while redoing that 9 A I have, I could just upgrade the
clutch kit (pressureplate etc) to a 16v model)?

Patrick



=>-----Original Message-----
=>From: Brian Wagner [mailto:scirocco_88_16v@hotmail.com]
=>Sent: Tuesday, January 29, 2002 7:11 AM
=>To: pbureau@attbi.com; scirocco-l@scirocco.org
=>Subject: RE: Transmission question
=>
=>
=>I believe the only difference is the pressure plate, it is based with a
=>heavier load to compensate for the additional torque and hp.
=>Other than that
=>everything else is Identical.
=>
=>I could be wrong.
=>
=>Brian
=>
=>
=>>From: "ATS - Patrick Bureau" <pbureau@attbi.com>
=>>To: "_Scirocco Mailing List" <scirocco-l@scirocco.org>
=>>Subject: RE: Transmission question
=>>Date: Tue, 29 Jan 2002 04:49:00 -0600
=>>
=>>Question here,
=>>
=>>I though all 85> 8v/16v trannies where rthe same since the
=>clutch disc are
=>>all 210mm
=>>please advise.
=>>
=>>Patrick
=>>
=>>=>-----Original Message-----
=>>=>Yes, any large mainshaft (aka "16V") tranny will physically fit.  So
=>>=>will *any* 020 tranny even from an 8V car, provided you change the
=>>=>clutch disk.  No problem.  See the "gears" section under scirocco.org.
=>>
=>>
=>>_______________________________________________
=>>Scirocco-l mailing list
=>>Scirocco-l@scirocco.org
=>>http://neubayern.net/mailman/listinfo/scirocco-l
=>
=>
=>_________________________________________________________________
=>Chat with friends online, try MSN Messenger: http://messenger.msn.com
=>