[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

how to unsubscribe [fixed for us smart-asses who are going to use it]



Oh c'mon now!   in all honesty- the fastest way to unsubscribe from THIS 
list is too chuck your computer out the window and replace it with a new 
one.

:^)

Dan wrote:

> HOW TO UNSUB FROM THIS LIST YOURSELF
> 
> 
> First, ask your Internet Provider to mail you an Unsubscribing Kit.
> 
> Then follow these directions.
> 
> The kit will most likely be the standard no-fault type. Depending on
> requirements, System A and/or System B can be used. When operating System A,
> depress lever and a plastic dalkron unsubscriber will be dispensed through
> the slot immediately underneath. When you have fastened the adhesive lip,
> attach connection marked by the large "X" outlet hose. Twist the silver-
> coloured ring one inch below the connection point until you feel it lock.
> The kit is now ready for use. The Cin-Eliminator is activated by the small
> switch on the lip. When securing, twist the ring back to its initial
> condition, so that the two orange lines meet. Disconnect. Place the dalkron
> unsubscriber in the vacuum receptacle to the rear. Activate by pressing the
> blue button.
> 
> The controls for System B are located on the opposite side. The red release
> switch places the Cin-Eliminator into position; it can be adjusted manually
> up or down by pressing the blue manual release button. The opening is self-
> adjusting. To secure after use, press the green button, which simultaneously
> activates the evaporator and returns the Cin-Eliminator to its storage
> position. You may log off if the green exit light is on over the evaporator
> . If the red light is illuminated, one of the Cin-Eliminator requirements
> has not been properly implemented. Press the "List Guy" call button on the
> right of the evaporator . He will secure all facilities from his control
> panel.
> 
> To use the Auto-Unsub, first undress and place all your clothes in the
> clothes rack. Put on the velcro slippers located in the cabinet immediately
> below. Enter the shower, taking the entire kit with you. On the control
> panel to your upper right upon entering you will see a "Shower seal" button.
> Press to activate. A green light will then be illuminated immediately below.
> On the intensity knob, select the desired setting. Now depress the
> Auto-Unsub activation lever.
> 
> Bathe normally.
> 
> The Auto-Unsub will automatically go off after three minutes unless you
> activate the "Manual off" override switch by flipping it up. When you are
> ready to leave, press the blue "Shower seal" release button. The door will
> open and you may leave. Please remove the velcro slippers and place them in
> their container. If you prefer the ultrasonic log-off mode, press the
> indicated blue button. When the twin panels open, pull forward by rings A &
> B. The knob to the left, just below the blue light, has three settings, low,
> medium or high. For normal use, the medium setting is suggested.
> After these settings have been made, you can activate the device by
> switching to the "ON" position the clearly marked red switch. If during the
> unsubscribing operation, you wish to change the settings, place the "manual
> off" override switch in the "OFF" position. You may now make the change and
> repeat the cycle. When the green exit light goes on, you may log off and
> have lunch. Please close the door behind you.
> 
> Please Note:  In some later model unsubscribe kits, the "OFF" indicator has
> been replaced by "POWER-UP STANDBY ENABLE".  Accordingly the "ON" indicator
> has been replaced by the much clearer, "POWER-DOWN STANDBY ENABLE".  Contact
> your internet service provider for a list of affected model numbers.  An
> "ON-OFF" retrofit panel kit is available for those who have difficulty with
> the new and much clearer labeling.
> 
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
> 
> 
>