Who has info on eurothane filled stock motor mounts?

[Scirocco-Al" <scirocco-Al@insight.rr.com (Scirocco-Al)]

I've seen that page too.  I looked into doing that on the rear axle bushing
on my 240 Volvo.  The cost from McMaster-Carr for the Urethane was pretty
pricey.  The insert probably aren't as good but they are easier on the
pocket book
----- Original Message -----
From: "T Berk" <tberk@mindspring.com>
To: "Josh20V" <mkii@nycap.rr.com>
Cc: "Scirocco List" <scirocco-l@scirocco.org>
Sent: Tuesday, December 31, 2002 5:38 PM
Subject: Re: Who has info on eurothane filled stock motor mounts?


Josh20V wrote:
>
> on the inserts that go into the mouter mounts?
>
> Josh Able

That's is one way, and a useful link but there is also a DIY page that
shows pouring stuff in the stock mount, letting it harden and getting a
similar result. Kind of a hardware store approach.

TBerk

_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l