A2 trans into A1 body q'

[Rabbit16v@attbi.com (Rabbit16v)]

I read what Brian wrote (aka Decker) and realized that he hadn't mentioned
this.  The 4K is the exception to this rule, and with minor machining you
can put 100mm flanges on any 020 trans.

Dave
----- Original Message -----
From: "Jason Adams" <roclist@accessconsulting.ca>
To: "Chris DeLong" <green536@hotmail.com>; <boisfort@myhome.net>;
<Cmr446@cs.com>; <scirocco-l@scirocco.org>
Sent: Monday, December 23, 2002 9:17 AM
Subject: Re: A2 trans into A1 body q'


> The 4k from my '84 has 100mm flanges on it now...
>
>
> Jason Adams
> Fahrvergnugen Forever! ;)
> 84 rocco 16v
> 93 320i
> 98 Z71
>
>
> ----- Original Message -----
> From: "Chris DeLong" <green536@hotmail.com>
> To: <boisfort@myhome.net>; <Cmr446@cs.com>; <scirocco-l@scirocco.org>
> Sent: Monday, December 23, 2002 8:32 AM
> Subject: Re: A2 trans into A1 body q'
>
>
> > You are incorrect. There are many 90mm trannies that will accept 100mm
> > flanges. Any 90mm tranny after mid '85 will accept 100mm flanges.
> >
> >
> >
> > Chris DeLong
> > ICQ#45030867
> > Seattle, WA USA
> > '80 16V 'Rocco ragtop
> > '91 GLi 2.0 16V
> > '77 Rabbit 16V
> > '80 'Vert (parting out!)
> > '61 17 Window type II
> > '91 Vanagon
> > '78 Rabbit
> > '84 Jetta
> >
> >
> >
> >
> >
> > >From: "Decker" <boisfort@myhome.net>
> > >Reply-To: "Decker" <boisfort@myhome.net>
> > >To: <Cmr446@cs.com>,<scirocco-l@scirocco.org>
> > >Subject: Re: A2 trans into A1 body q'
> > >Date: Sun, 22 Dec 2002 13:07:16 -0800
> > >
> > >     Your tranny and axles should just bolt right up. The case is
> different
> > >on the transmissions that were made to use 100 mm flanges. There is no
> room
> > >for clearance for the 100mm flanges on the cases made for 90 mm
flanges.
> I
> > >just put my new tranny built by V/L in Hillsboro OR In my 79 Scirocco
> > >coupled to a 1800 cc 85 Audi engine 10.1 compression and a 272
hydraulic
> > >cam. The tranny is built on a 9A case but I am using 90 mm flanges. I
> used
> > >the drivers side axle that was in my 79 Scirocco which had an FF tranny
> in
> > >it when I bought it and the right side axle I borrowed from my 80
Rabbit
> > >pickup which also had an FF tranny. I bet if you measure from the
outside
> > >of
> > >one flange to the other you will probably find the width is pretty much
> the
> > >same on the FN or your 9A. My new tranny Is installed in my 79 Scirocco
> and
> > >it is totally awesome. Here are the spec's. 9A case, Quaife diff.
> > >(everybody
> > >should have a Quaife ), 3.89 final, 3.45 1st, 2.11 2nd, 1.44 3rd, 1.12
> 4th,
> > >.91 5th, and .71 6th. The transmission was rebuilt by Vince Lacerio
using
> > >his V/L sixth speed adapter.
> > >Brian Decker
> > >----- Original Message -----
> > >From: <Cmr446@cs.com>
> > >To: <scirocco-l@scirocco.org>
> > >Sent: Sunday, December 22, 2002 11:10 AM
> > >Subject: A2 trans into A1 body q'
> > >
> > >
> > > >   Ok, I have a 9A from an '88 Golf to install into my '77 rocco,
> > >swapping
> > >the
> > > > 100mm flanges with a set of 90mm's and new seals (Thanks to
> Adirondack).
> > > > Another  difference I found was the flanges stick about 3/4" out
from
> > >the
> > > > diff than the GC 4spd or the FN that's in my car now.
> > > >   Question is, were the axles for A2 cars made shorter for the
> > >difference
> > > > that the flanges set out from the case or will the A1 axles fit up
> > >without
> > > > any problem?
> > > >   Or am I overthhinking this and it's all easier than I'm making it?
> > > >
> > > > Carl
> > > > 77rocco
> > > > 89fox  - donor to be
> > > > 03saturn - can not modify under penalty of wife!
> > > > 00hyundai - rental, further heap the indignities
> > > >
> > > > _______________________________________________
> > > > Scirocco-l mailing list
> > > > Scirocco-l@scirocco.org
> > > > http://neubayern.net/mailman/listinfo/scirocco-l
> > >
> > >
> > >_______________________________________________
> > >Scirocco-l mailing list
> > >Scirocco-l@scirocco.org
> > >http://neubayern.net/mailman/listinfo/scirocco-l
> >
> >
> > _________________________________________________________________
> > The new MSN 8: smart spam protection and 3 months FREE*.
> >
>
http://join.msn.com/?page=features/junkmail&xAPID=42&PS=47575&PI=7324&DI=747
> 4&SU=
> >
>
http://www.hotmail.msn.com/cgi-bin/getmsg&HL=1216hotmailtaglines_smartspampr
> otection_3mf
> >
> >
> > _______________________________________________
> > Scirocco-l mailing list
> > Scirocco-l@scirocco.org
> > http://neubayern.net/mailman/listinfo/scirocco-l
> >
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>