wanted 30-34 lb injectors

[sfwilliams@comcast.net (Scott F. Williams)]

Mike, I can get you high-impedance 30# for $100 a set. I can also supply 36#
low-impedance units for the same amount. Either way the catch is that you
have to wait a couple of weeks for them to come in. Btw, these are used Ford
Motorsports injectors. I use them straight out the box, but having them
tested and rebuilt for $25 a pop is a smart investment.

So, why not use low impedance injectors for the better idle control? The
bigger injectors will also give you more headroom to make more power.
Meanwhile, a 30# injector is merely adequate. As the SDS website says "SDS
will drive most low impedance (1.7 to 3 ohm) or high impedance (12 to 16
ohm) injectors." I suppose that your injector drive harness is already set
up for the high-impedance types?.. Well, assuming that a low-impedance
harness is inexpensive and easy to convert I'd go in that direction.

Whereas RC engineering and similar firms will supply suitable squirters for
about $85 each, I can set you up for a fraction of that -even after they're
rebuilt to as good as new (or nearly so).

Lemme know if I can help you out, meng.
--
Scott F. Williams
NJ Scirocco nut
'99 Subaru Impreza 2.5 RS
Mazda 323 GTX turbo "assaulted" vehicle
Golf GTI 16v "rollycar"
ClubVAC: "Roads found. Drivers wanted."

> -----Original Message-----
> From: scirocco-l-admin@scirocco.org
> [mailto:scirocco-l-admin@scirocco.org]On Behalf Of Mike Blain
> Sent: Thursday, August 08, 2002 8:10 AM
> To: scirocco-L@scirocco.org
> Subject: wanted 30-34 lb injectors
>
>
> anyone have 30-34 lb injectors?
> High impedance?
> 12-14 ohms?
>
> for sale x4?