i need your opinion on hp numbers for my project please!!!!!

[roccolister@hotmail.com (Craig Williams)]

Well,

It all depends who does your port & polish, but I think that your figures 
are a bit optomistic. Since you didn't mention what kind of fuel and 
ignition you want to run, I imagine you will be running CIS-e, and with that 
you won't get anywhere near 200 hp unless you're building a tear down race 
motor.

If you look at wheel HP, I think that the best you'll be able to put down 
using CIS-e is about 150, and even that's tough. Again...at the wheels so 
you gotta figure that's equal to about 170 at the crank.

I just installed my new TT system this weekend, and now I've gotta set up a 
dyno run. I'm HOPING to see at least close to 150 at the wheels, but I don't 
know if I'm gonna make it.

-- Craig


>From: JCJJCC@aol.com
>To: scirocco-l@scirocco.org
>Subject: i need your opinion on hp numbers for my project please!!!!!
>Date: Sun, 4 Aug 2002 23:20:47 EDT
>
>i am about to put a 16v together. i have a set of 272 cams, im gonna get a 
>9A
>block, and port and polish a 1.8 head. what kinda horse power numbers 
>should
>i expect at the block???? i am getting mixed numbers.now i have heard that
>the cams yeild @25hp
>the port and polish yeilds @20hp
>the 2.0 block stock has 134 then with the 1.8 head it has around 150-155hp.
>are all these numbers bogus???
>i am hoping to get at least 170-175hp and adding these numbers up should 
>get
>me 195-200bhp. could some one please help me out with this??!! thanks, L.J.
>
>
>
>
>
>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l




_________________________________________________________________
MSN Photos is the easiest way to share and print your photos: 
http://photos.msn.com/support/worldwide.aspx