Re: Brakes and Q's (long)

["Brian Wagner" <scirocco_88_16v@hotmail.com>]

Only the rears require a 12mm hex (because of the mechanical rachet for the
ebrake). C clamp on the front works fine.

Brian
88 16v
87 16v
----- Original Message -----
From: "Cheapass Ron" <rapieper@yahoo.com>
To: "timothy piwonka" <t.piwonka@worldnet.att.net>; "scirocco-l"
<scirocco-l@scirocco.org>
Sent: Tuesday, July 31, 2001 6:05 PM
Subject: Re: Brakes and Q's (long)


> --- timothy piwonka <t.piwonka@worldnet.att.net>
> wrote:
> >
> > >If you are replacing your pads you may need to
> > recess the brake piston to
> > >allow the pads to clear the new rotor.  For that
> > you need a large allen key
> > > (don't remember size).
> >
> > This is s 12mm allen on my 16V, same on front and
> > back
> >
>
> Need a 12mm allen on the fronts?   Thought I used a
> C-clamp and all was right in the world...hmmm...
>
> =====
> Ron (Cheapass)
> '87 16V, ("Victor"), '93 Cabby ("Teufelhasen")
> ICQ 108845455
>
> If it ain't foggy, TURN OFF YOUR FOG LIGHTS.
>
> __________________________________________________
> Do You Yahoo!?
> Make international calls for as low as $.04/minute with Yahoo! Messenger
> http://phonecard.yahoo.com/
>
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the message to
majordomo@scirocco.org
>
>

--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org