[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Bad rod bearing?

To: jonas85k@hotmail.com, scirocco-l@scirocco.org
Subject: Re: Bad rod bearing?
From: UrGTI@aol.com
Date: Tue, 9 May 2000 14:11:09 EDT
Sender: owner-scirocco-l@scirocco.org

When you had the pan off you could have checked the play in the rods at the 
crank.
The two rod knocking motors I have seen you could grab the rod and move it 
forward and back (perpindicular) to the crank and make it knock on your own . 

Dont know about just swapping out bearings never done that or had a "new" 
motor . 

Jasin
16v S

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org

Follow-Ups:
- RE: Bad rod bearing?
  - From: "Shannon Fenton" <sfenton@amazon.com>

Prev by Date: Glueing rotor on 16v
Next by Date: Re: ITS ALIVE!! ITS ALIVE MUWAHAHAH!!
Prev by thread: Re: Bad rod bearing?
Next by thread: RE: Bad rod bearing?
Index(es):
- Date
- Thread