Re: Bad Block?

["Gerry Reichelt" <greichelt@mmcable.com>]

   Is there any reason  the cylinder couldn't be sleeved? I don't know if
there are any machine shops in our area capable of doing this.
   Gerry
----- Original Message -----
From: "jonas miller" <sjmill@erols.com>
Subject: Re: Bad Block?
> ahhh   but you cabn repair a damaged cylinder hone...it is called over
boree,
> time to buy some bigger pistons, that is all...that should correct it
unless
> the damage is so severe that you could not over bore iut to 84.00mm then
it is
> trashed completly
> jonas



--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org