Re: 2.0 Swap Parts List

[Eric L Ellis <elf16v@juno.com>]

Don't forget the intermediate shaft bearings! Valve cover gasket should
be in the head kit. How about injector insulators. Don't forget to
balance the engine!

-Eric
Good, bad....I'm the guy with the gun!


On Tue, 18 Apr 2000 18:14:32 -0700 "Shannon Fenton" <sfenton@amazon.com>
writes:
> Anything Im forgeting when rebuilding a used 2.0 short block? I have 
> a new
> head and it will be ported and polished prior with my euro cam, so 
> nothing
> there....I want to not work on the car for a very long time since 
> this going
> to be costly. Heres what Im planning on so far....
> 
> 
> Clutch
> Rod and Main Bearings
> Piston Rings
> Head Gasket Kit
> Block Gasket Kit
> Valve Cover Gasket
> Head Bolts
> Motor Mounts
> Timing Belt Tensioner
> New Belts
> Water Pump
> Injector O Rings
> OXS Sensor
> Maybe new injectors
> Maybe new downpipe with a cat put back in
> 
> 
> Thank you for your time.
> Shannon Fenton
> Telecom Resource Management
> Amazon.com
> 206.266.6736
> sfenton@amazon.com


--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org