Re: cat install. with header

["Bryan Geiszler" <wubbledub@hotmail.com>]

<x-flowed>I have seen a header in the JC Whitney catalog made by Pacesetter that is 
suposed to work with a cat and O2 sensor.  Don't know the pipe diamiter or 
anything else about it but there it is.

Bryan Geiszler
'81 Scirocco
----Original Message Follows----
From: "Gerry Reichelt" <greichelt@mmcable.com>
To: <scirocco-l@scirocco.org>
Subject: Re: cat install. with header
Date: Sat, 2 Oct 1999 16:39:23 -0500

     I hope you find a workable solution. I went through the same thing a
while back. I wasn't able to find any header, cheap or expensive, that would
allow use of the cat and the O2 sensor. Let us know if you can work it out.
     Gerry
----- Original Message -----
From: Geoffrey Morton <joyridegm@netscape.net>
To: <scirocco-l@scirocco.org>
Sent: Saturday, October 02, 1999 7:31 AM
Subject: cat install. with header


i just ripped out my exhaust manifold, downpipe, and cat and installed a
eurospec header on my 8716v. i already have an autotech sportuned aluminized
system on there and i was wondring how to fit the cat on . the problem is my
header is alot longer than the downpipe was and i cant really cut much on
the
header because it has a ball joint. i am just running a straight pipe
without
a cat, but ma is ridiculous about emissions and i have to put the cat on to
pass. let me know if you have ideas.thanks
geoff 87rocco16v


______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org


</x-flowed>