Re: Sway bars

[Jim Jarrett <jarrett@rpa.net>]

<x-flowed>At 2:06 PM -0800 12/12/99, Timothy A Reed wrote:
>Hi,
>
>What is involved in putting sway bars from a 16v onto an 8v?
>TIA.


-Swapping 16v A-arms over.  It has the holders for the rear brackets. 
They also has pre-drilled holes for the front brackets.(Might as well 
do ball joints whilst you're there!)

-Drilling 2 holes in the frame for the lower frame bar.

/===============================================================\
| Jim Jarrett                      http://www2.rpa.net/~jarrett |
| jarrett@<NOSPAM>rpa.net                                       |
|                                                               |
|    Any problem can be solved with the proper application of   |
|   Force, Heat, Chemicals, or Money.                           |
\===============================================================/

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org


</x-flowed>